GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 41396 Park Lock Cable Pliers


    Object Number: 361440  Size: SH

    Important: Lubricate all moving parts of the linear shift assembly with synthetic grease.

  1. Install the gearshift lever assembly support bracket.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the 3 flat head 6-lobed socket tap screws.
  4. Tighten
    Tighten the screws to 10 N·m (89 lb in).


    Object Number: 361439  Size: SH
  5. Insert the cam bushing (2) into the cable shift cam assembly (1).
  6. Install the cable shift cam assembly (1).
  7. Install the hexagon flange head bolt.
  8. Tighten
    Tighten the screw to 18 N·m (14 lb ft).


    Object Number: 361438  Size: SH
  9. Install the park lock cable assembly and secure by using the 2 oval head 6-lobed socket tap screws.
  10. Tighten
    Tighten the screws to 6.5 N·m (58 lb in).


    Object Number: 361435  Size: SH
  11. Install the shift lever clevis (1).
  12. Install the ball actuator assembly (2).
  13. Install the hexagon flanged head bolt.
  14. Tighten
    Tighten the bolt to 18 N·m (14 lb ft).

  15. Put the column in the NEUTRAL position.
  16. Install the automatic transmission shift lock control only. Refer to Automatic Transmission Shift Lock Control Assemble - Off Vehicle .

  17. Object Number: 324884  Size: SH
  18. Adjust the park lock cable assembly using the following steps:
  19. 12.1. Use the shift lever clevis to put the column in the PARK position.
    12.2. Put the ignition switch in the OFF-LOCK position. Remove the key.
    12.3. Unlock the adjuster ring (1) on the park lock cable assembly with J 41396 .
    12.4. Pull on the cable until the park lock latch contacts the shift lever clevis. Release the cable.
    12.5. Lock the adjuster ring (1) securely in place on the park lock cable assembly with J 41396 .
  20. Inspect the park lock cable assembly using the following steps:
  21. 13.1. Put the lock cylinder in the OFF-LOCK position. The shift lever clevis should not be able to shift out of the PARK position.
    13.2. Turn the key to the RUN position and put the shift lever clevis in the NEUTRAL position.
    13.3. With the shift lever clevis in the NEUTRAL position the lock cylinder should not be able to go into the OFF-LOCK position.
    13.4. Put the shift lever clevis into the PARK position.
    13.5. Put the lock cylinder in the OFF-LOCK position and then remove the key.
    13.6. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .