Tools Required

J 43631 Ball Joint Separator

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.



3. Remove the retaining bolt for the brake hose and the wheel speed sensor brackets.
4. Remove the halfshaft. Refer to Halfshaft Assembly Replacement in Front Drive Axle.
5. Remove the nut at the upper ball joint. Discard the nut.
6. Disconnect the upper control arm from the steering knuckle using J 43631 .



7. Remove the upper control arm nuts and the adjustment cams (2) (15 Series RWD, 4WD, and 25 Series RWD).
8. Remove the upper control arm bolts (4) (15 Series RWD, 4WD, and 25 Series RWD).



9. Remove the upper control arm nuts and the adjustment cams (2) (25 Series 4WD).
10. Remove the upper control arm bolts (4) (25 Series 4WD).
11. Remove the upper control arm.

1. Install the upper control arm.



2. Install the upper control arm bolts (4) (25 Series 4WD).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the upper control arm nuts and the adjustment cams (2) (25 Series 4WD).

Tighten
Tighten the nuts to 190 N·m (140 lb ft).




4. Install the upper control arm bolts (4) (15 Series RWD, 4WD, and 25 Series RWD).
5. Install the upper control arm nuts and the adjustment cams (2) (15 Series RWD, 4WD, and 25 Series RWD).

Tighten
Tighten the nuts to 190 N·m (140 lb ft).

6. Connect the upper control arm to the steering knuckle .
7. Install the halfshaft. Refer to Halfshaft Assembly Replacement in Front Drive Axle.
8. Install the new nut to the upper ball joint stud.

Tighten
Tighten the nut to 50 N·m (37 lb ft).




9. Install the retaining bolts for the brake hose and wheel speed sensor brackets.

Tighten
Tighten the bolts to 9 N·m (80 lb in).

10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
11. Remove the safety stands.
12. Lower the vehicle.
13. Verify the wheel alignment. Refer to Wheel Alignment Specifications in Wheel Alignment .