Removal Procedure
- Remove the transmission. Refer to Transmission Replacement or Transmission Replacement .
- Remove the two bolts securing the actuator cylinder to the clutch housing.
- Remove the actuator cylinder from the transmission input shaft.
If required, the bearing can be removed from the actuator cylinder for replacement.
Installation Procedure
- Position the actuator cylinder to the transmission input shaft.
- Secure the actuator cylinder to the clutch housing with two bolts.
- Install the transmission. Refer to Transmission Replacement or Transmission Replacement .
Ensure that the bleed screw and the coupling are positioned toward the transmission ports.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 8 N·m (71 lb in).
