Removal Procedure
- Disconnect the battery negative cable from the battery.
- Remove the drive belt from the vehicle. Refer to Drive Belt Replacement .
- Remove the drive belt idler pulley and bolt from the engine.
Caution: Before servicing any electrical component, the ignition and start switch must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.
Installation Procedure
- Install the drive belt idler pulley to the engine.
- Install the drive belt idler pulley retaining bolt.
- Install the drive belt. Refer to Drive Belt Replacement .
- Connect the battery negative cables to the battery. Refer to Battery Cable Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolt to 83 N·m (61 lb ft).
