GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the rear seat from the vehicle. Refer to Rear Seat Replacement .

  2. Object Number: 276675  Size: MH
  3. Remove the rear passenger seat riser.
  4. Remove the hog rings and/or the J-clips from the rear edge of the seat cushion cover (3).
  5. Disconnect the rear heater connector, if equipped.
  6. Remove the seat belt buckles, if required. Refer to Seat Belt Buckle and Latch Replacement - Rear .
  7. Remove all of the remaining hog rings, and/or the J-clips that are retaining the seat cushion cover (3) to the seat cushion frame (8).
  8. Release the hook, and the loop-strips that are retaining the seat cushion cover to the foam pad (4).
  9. Remove the center screw retaining the latch cover, if equipped.
  10. Remove the seat cushion cover from the foam pad.

Installation Procedure


    Object Number: 276675  Size: MH
  1. Install the seat cushion cover to the foam pad.
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the center screw retaining the latch cover, if removed.
  4. Tighten
    Tighten the screw to 2 N·m (18 lb in).

  5. Engage the hook, and the loop-strips that are retaining the seat cushion cover (3) to the foam pad (4).
  6. Install the seat buckles, if removed. Refer to Seat Belt Buckle and Latch Replacement - Rear .
  7. Connect the rear heater connector, if equipped.
  8. Install the hog rings, and/or the J-clips in order to retain the seat cushion cover to the seat cushion frame (8).
  9. Install the rear passenger seat risers.
  10. Install the rear seat to the vehicle. Refer to Rear Seat Replacement .