Step
| Action
| Normal Result(s)
| Abnormal Result(s)*
|
IMPORTANT: When performing the following checks, maintain some moisture
on the front windshield so that the wiper motor does not overheat.
|
1
|
- Turn the ignition switch to the ON position.
- Leave the Wiper Switch in the OFF position.
- Depress the washer switch for 2 to 4 seconds and release.
|
• | Wipers operate at low speed. |
• | Washer sprays windshield as long as washer switch is held in the
ON position. |
• | After releasing switch, washer stops and wipers return to park
position after 2 to 4 sweeps. |
| Refer to
Washers Inoperative
.
|
2
|
- Move the wiper switch to the INT position.
- Rotate the INT ADJ switch from the high to low delay position.
|
• | Wipers make one complete sweep, then pause before making next
sweep. |
• | The pause time is adjusted by turning the INT ADJ switch through
the delay range. |
| Refer to
Wipers Delay Mode Inoperative
.
|
3
|
- Leave the wiper switch in the INT position.
- Depress the washer switch for 2 to 4 seconds and release.
|
• | Washer sprays windshield as long as washer switch is held in the
ON position. |
• | Wipers run at low speed while spraying and continue for 2 to 4
sweeps after washer switch is released. |
• | Wipers then return to pulse operation. |
|
|
4
| Move the wiper switch to the LO position.
| Wipers run
continuously at low speed.
| Refer to
Wipers All Modes Inoperative
|
5
| Move the wiper switch to the HI
position.
| Wipers run continuously at high speed.
|
|
6
| Move the wiper switch to the OFF position.
| Wipers return
to the park position at low speed.
| Refer to
Wipers Always On
.
|
7
| Move the wiper switch to the MIST position
and then release.
| Wipers make one complete sweep, then return to the park
position.
|
|
* Refer to the appropriate symptom diagnostic
table for the applicable abnormal result.
|