1

1. Close all of the vehicle's doors.
2. Leave the safety belt unbuckled.
3. Verify the gear selector is in the PARK position.
4. Turn the ignition switch to the ON position.

The vehicle performs a bulb check on the indicators. The following indicators illuminate briefly:

2

1. Buckle the driver's safety belt.
2. Observe the fasten safety belt indicator.

The fasten safety belt indicator is off.

Fasten Safety Belt Indicator/Chime Always On .

3

Apply the park brake.

The park brake indicator illuminates.

Park Brake Indicator Inoperative. Hydraulic Park Brake Diagnostic .

4

Each turn signal indicator flashes.

Exterior Lights System Check .

5

The DRL indicator does not illuminate or turn off with the Park Brake applied. Daytime Running Lights (DRL) System Check .

6

Turn the headlights on.

The I/P Cluster illumination turns on and dims to the setting on the dimmer control.

I/P Cluster illumination lamps do not turn on or dim. Interior Lights Dimming System Check .

7

Adjust the instrument panel dimmer control.

The I/P Cluster illumination varies based on the dimmer control adjustment.

I/P Cluster Illumination Does Not Vary. Interior Lights Dimming System Check .

8

Turn the high beam headlamps on.

The high beam indicator illuminates.

9

Observe the Service Engine Soon indicator.

Service Engine Soon indicator is off.

Service Engine Soon Indicator is always on. Malfunction Indicator Lamp Circuit Check / Malfunction Indicator Lamp Circuit Check / Malfunction Indicator Lamp (MIL) Inoperative .

10

Observe the battery charge indicator.

The battery charge indicator is off.

Battery Charge Indicator Always On. Charging System Check .

11

Observe the Air Bag indicator.

The Air Bag indicator is off.

Air Bag Indicator On. SIR Diagnostic System Check .

12

Observe the ABS indicator.

The ABS indicator is off.

ABS Indicator On. ABS Diagnostic System Check .

13

Observe the SECURITY indicator.

The SECURITY indicator is off.

Security Indicator On. Diagnostic System Check - Theft Deterrent .

14

Cycle the gear selector lever through all of the gear positions.

The PRNDL displays the correct gear positions.

15

Turn the hazard flashers on.

Both turn indicators flash.

Hazard flashers inoperative. Exterior Lights System Check .

* Refer to the appropriate symptom diagnostic table for the applicable abnormal result.

1

1. Start the engine.
2. Observe the engine oil gauge.

Engine oil pressure should read within the normal range.

2

Observe the fuel gauge.

The fuel gauge indicates the correct fuel level.

3

1. Ensure the engine is at operating temperature.
2. Observe the engine temperature gauge.

The engine temperature gauge indicates the correct engine temperature.

4

Observe the voltmeter.

Voltmeter indicates a charge of 13 - 14.5 volts.

Volt Gage Inaccurate or Inoperative .

5

Observe the tachometer.

The tachometer indicates the correct engine speed.

6

Drive vehicle at 30 mph (48 km/h) over a known distance.

The speedometer and the odometer operate properly.

* Refer to the appropriate symptom diagnostic table for the applicable abnormal result.