Removal Procedure
- Remove the trim panel. Refer to
Upper Extension Trim Panel Replacement
.
- Remove the water deflector. Refer to
Rear Side Door Water Deflector Replacement
.
- Remove the inner mounting panel assembly. Refer to
Front Door Module Replacement
.
- Remove the outside handle rod from the rod clip.
- Remove the lock cylinder
rod from the rod clip.
- Remove the outside handle mounting screws.
- Remove the door lock cylinder from the outside handle housing.
In order to repair a binding lock cylinder, refer to
Lock Cylinder Binding
.
- Remove the handle.
Installation Procedure
- Install the handle to
the vehicle.
- If the lock cylinder is a replacement, apply a coating of GM P/N 12345120
or a similar lubricant to the inside of the lock case and the cylinder keyway.
- Install the door lock cylinder to the outside handle housing.
In order to code a new lock cylinder, refer to
Key and Lock Cylinder Coding
in General Information.
- Install the lock cylinder rod to the lock cylinder clip.
- Install the handle rod to the handle assembly clip.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the outside
handle mounting bolts.
Tighten
Tighten the bolts to 4 N·m (35 lb in).
- Install the inner mounting panel assembly. Refer to
Front Door Module Replacement
.
- Install the water deflector. Refer to
Rear Side Door Water Deflector Replacement
.
- Install the trim panel. Refer to
Upper Extension Trim Panel Replacement
.