Front Fog Lamp Replacement All Except Bravada, Envoy

The fog lamp assembly consists of the following components:

If the lens is broken, the assembly must be replaced. If the bulb is burned out, the bulb may be replaced separately.

1. Ensure that the fog lamp switch is in the OFF position.
2. Remove the bumper. Refer to Front Bumper Impact Bar Replacement in Bumpers.
3. Disconnect the electrical connectors as necessary.



4. Remove the screws that secure the fog lamp assembly to the bumper.
5. Remove the fog lamp assembly from the bumper.

1. Install the fog lamp assembly to the bumper.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the screws that secure the fog lamp assembly to the bumper.

Tighten
Tighten the fog lamp assembly screws to 10 N·m (88 lb in).

3. Connect the electrical connectors as necessary.
4. Install the bumper. Refer to Front Bumper Impact Bar Replacement in Bumpers.

Front Fog Lamp Replacement Bravada Only

1. Ensure that the fog lamp switch is in the OFF position.
2. Disconnect the electrical connector.



3. Remove the screws that retain the fog lamp assembly to the bumper.
4. Remove the fog lamp assembly from the bumper.

1. Install the fog lamp assembly to the bumper.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the screws that secure the fog lamp assembly to the bumper.

Tighten
Tighten the screws to 10 N·m (88 lb in).

3. Connect the electrical connector.

Front Fog Lamp Replacement Envoy Only

1. Ensure that the foglamp switch is OFF.
2. Ensure that the ignition switch is in the LOCK position.



3. Rotate the bulb socket 1/4 turn counter-clockwise in order to remove the socket from the foglamp assembly.
4. Remove the bulb from the socket.
5. Remove the push-pin style retainers that retain the foglamp to the front fascia.
6. Remove the adjustment thumbwheel from the foglamp.
7. From the front of the vehicle, remove the foglamp from the fascia.

1. From the front of the vehicle, install the foglamp to the fascia.
2. Install the adjustment thumbwheel to the foglamp.
3. Install the push-pin style retainers that retain the foglamp to the front fascia.
4. Install the foglamp bulb to the socket.
5. Rotate the bulb socket 1/4 turn clockwise in order to install the socket to the license plate lamp assembly.
6. Re-aim the fog lights. Refer to Fog Lamp Aiming .