Engine Mount Replacement Front Mount

Notice: Broken or deteriorated mounts can cause misalignment and destruction of certain drive train components. When a single mount breaks, the remaining mounts are subjected to abnormally high stresses.

1. Disconnect the battery negative cable. Refer to Battery Cable Replacement in Engine Electrical.
2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
3. Remove the engine mount through-bolt and nut for the side being replaced.

Notice: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Lifting the engine in an unapproved manner may cause component damage.




4. Raise and support the engine enough to remove the mount.
5. Remove the bolts for the frame side mount.
6. Remove the frame side mount.



7. Remove the bolts for the engine side mount.
8. Remove the engine side mount and the shield.

1. Sub-assemble the mount, shield, and one bolt.



2. Install the mount and shield to the engine.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the remaining bolts.

Tighten
Tighten the bolts to 59 N·m (44 lb ft).




4. Install the mount to the frame.
5. Install the bolts.

Tighten
Tighten the bolts to 59 N·m (44 lb ft).

6. Lower the engine.



7. Install the through-bolt and nut.

Tighten
Tighten the bolts to 95 N·m (70 lb ft).

8. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
9. Connect the battery negative cable. Refer to Battery Cable Replacement in Engine Electrical.