Tools Required

J 39084 Rear Crankshaft Oil Seal Installer

Important: Before a new seal is installed, the CDR and the crankcase ventilation system should be thoroughly inspected and the crankcase pressure should also be checked. Refer to Engine Controls-6.5L.

1. Disconnect the battery negative cables from the batteries.

•	For the front battery, refer to Battery Cable Replacement in Engine Electrical.

•	For the auxiliary battery, refer to Battery Cable Replacement in Engine Electrical.

2. Remove the engine cover from the vehicle. Refer to Engine Cover Replacement in Body and Accessories.
3. Remove the transmission from the vehicle. Refer to Transmission Replacement in Transmission/Transaxle.
4. Remove the flywheel from the crankshaft. Refer to Engine Flywheel Replacement .
5. Remove the crankshaft rear oil seal from the engine block.

Tools Required

J 39084 Rear Crankshaft Oil Seal Installer

Important: Coat the crankshaft surface with clean engine oil, and lightly coat the sealing area of the new oil seal with engine oil or grease before installing the new oil seal. Do not scratch or nick the sealing edge of the oil seal.

1. Install the crankshaft rear oil seal into the tool, with the spring cavity towards the engine, onto the crankshaft.
2. Use the J 39084 to install the crankshaft rear oil seal in the engine block.
3. Install the flywheel on to the crankshaft. Refer to Engine Flywheel Replacement .
4. Install the transmission in the vehicle. Refer to Transmission Replacement in Transmission/Transaxle.
5. Install the engine cover in the vehicle. Refer to Engine Cover Replacement in Body and Accessories.
6. Connect the battery negative cables to the batteries.

•	For the front battery, refer to Battery Cable Replacement in Engine Electrical.

•	For the auxiliary battery, refer to Battery Cable Replacement in Engine Electrical.