Crankshaft Rear Oil Seal and Housing Replacement Housing

1. Remove the transmission assembly and the flywheel. Refer to Transmission Replacement and Transmission Replacement in Transmission/Transaxle.



2. Remove the following fasteners from the oil seal housing:

•	Three screws using a T27 TORX® wrench and one nut.

•	Two lower studs using an E7 TORX® wrench.




3. Remove the oil seal housing.



4. Remove the gasket and discard it. Refer to Crankshaft Rear Oil Seal and Housing Removal .
5. Clean all sealing surfaces.
6. Inspect the crankshaft rear oil seal housing for warping, cracks, wear, or damage.

1. Install a NEW crankshaft rear oil seal housing gasket.



2. Install the oil seal housing to the engine block. Refer to Crankshaft Rear Oil Seal and Housing Installation .




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the following fasteners to the oil seal housing:

•	Three screws using a T27 TORX® wrench and one nut.

•	Two lower studs using an E7 TORX® wrench.

Tighten

•	Tighten the crankshaft rear oil seal housing screws and nut to 12 N·m (106 lb in).

•	Tighten the lower studs to 6 N·m (53 lb in).

•	Install the transmission assembly and the flywheel. Refer to Transmission Replacement and Transmission Replacement in Transmission/Transaxle.

Crankshaft Rear Oil Seal and Housing Replacement Seal

1. Remove the flywheel and transmission assembly. Refer to Transmission Replacement or Transmission Replacement in Transmission/Transaxle.



2. Remove the crankshaft rear oil seal from the crankshaft rear oil seal housing. Insert a suitable tool into the access notches and then carefully pry the cranshaft rear oil seal from the crankshaft rear oil seal housing.
3. Discard the crankshaft rear oil seal.

Tools Required

J 35621-A Crankshaft Rear Oil Seal Installer.

1. Use the J 35621-A in order to install the NEW oil seal.
2. Install the crankshaft rear oil seal using the the Crankshaft Rear Mail Seal Installer. Refer to Crankshaft Rear Oil Seal and Housing Replacement .
3. Install the engine flywheel and transmission assembly. Refer to Transmission Replacement or Transmission Replacement in Transmission/Transaxle.