- Remove the key from the ignition switch.
- Connect the passenger
yellow 2-way connector.
- Install the connector position assurance to the passenger yellow
2-way connector.
- Install the passenger knee bolster. Refer to
Passenger Knee Bolster Replacement
in Instrument
Panel, Gauges and Console.
- Connect the driver yellow
2-way connector (2) located at the base of the steering column.
- Install the connector position assurance (CPA) (1) to the driver
yellow 2-way connector located at the base of the steering column.
- Install the driver knee bolster. Refer to
Driver Knee Bolster Replacement
in Instrument Panel,
Gauges and Console.
- Install the AIR BAG Fuse to the IP fuse block.
- Staying well away from both air bags, turn the ignition switch
to the RUN position.
9.1. | The AIR BAG warning lamp will flash 7 times. |
9.2. | The AIR BAG warning lamp will then turn OFF. |
- Perform the SIR Diagnostic System Check if the AIR BAG warning
lamp does not operate as described.