DEFINITION: The low-speed mode, the delay mode, and the mist mode are inoperative. The high-speed mode is operating normally.

Was the Wiper/Washer System Check performed?

--

Go to Step 2

Go to Wiper/Washer System Check

1. Turn the ignition switch to the RUN position.
2. Turn the wiper switch to the LO position.
3. Measure the voltage between wiper/washer switch connector C211, terminal E8, and ground.

Is the voltage greater than the specified value?

1 volt

Go to Step 3

Go to Step 7

Measure the voltage between wiper/washer switch connector C211, terminal E5, and ground.

Is the voltage greater than the specified value?

1 volt

Go to Step 4

Go to Step 7

1. Disconnect the wiper motor connector.
2. Measure the voltage between wiper motor connector, terminal A, and ground.

Is the voltage greater than the specified value?

1 volt

Go to Step 5

Go to Step 10

Measure the voltage between the wiper motor connector, terminal E, and ground.

Is the voltage greater than the specified value?

1 volt

Go to Step 6

Go to Step 11

Replace the wiper motor cover assembly. Refer to Windshield Wiper System Module Replacement .

--

Go to Wiper/Washer System Check

--

Inspect the wiper/washer switch connector for a poor connection.

Did you find a poor connection?

--

Go to Step 8

Go to Step 9

Repair the poor connection. Refer to Connector Repairs .

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Replace the wiper switch. Refer to Multifunction, Turn Signal and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column.

Is the replacement complete?

--

Go to Wiper/Washer System Check

--

Repair the open in CKT 113. Refer to Wiring Repairs .

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Repair the open in CKT 112. Refer to Wiring Repairs .

Is the repair complete?

--

Go to Wiper/Washer System Check

--