Circuit Description
The fuel temperature sensor is a thermistor type sensor. The engine control module (ECM) supplies 5 volts and a ground circuit to the sensor. When the ECM detects a fuel temperature sensor above a pre-determined value, a type C code, no malfunction indicator lamp (MIL) sets. A fuel cooler located in front of the fuel tank is used to help keep the fuel temperature at an acceptable limit.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC P0168 Engine Fuel Over-Temperature
Conditions for Running the DTC
| • | The ignition is ON. |
| • | DTC P0168 runs continuously within the enabling conditions. |
Conditions for Setting the DTC
The fuel temperature sensor is above 122°C (252°F) for more than 5 seconds.
Action Taken When the DTC Sets
| • | The control module stores the DTC information into memory when the diagnostic runs and fails. |
| • | The malfunction indicator lamp (MIL) will not illuminate. |
| • | The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Failure Records. |
| • | The driver information center, if equipped, may display a message. |
Conditions for Clearing the DTC
| • | A current DTC Last Test Failed clears when the diagnostic runs and passes. |
| • | A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic. |
| • | Clear the DTC with a scan tool. |
Test Description
The numbers below refer to the step numbers on the diagnostic table.
Step | Action | Values | Yes | No |
|---|---|---|---|---|
Schematic Reference: Engine Controls Schematics Connector End View Reference: Engine Control Module Connector End Views or Engine Controls Connector End Views | ||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 | Inspect the fuel lines for kinks or damage. Did any of the components require a repair? | -- | Go to Step 11 | Go to Step 3 |
3 |
Is the voltage near the specified value? | 5 V | Go to Step 4 | Go to Step 5 |
4 |
Does the test lamp illuminate? | -- | Go to Step 7 | Go to Step 6 |
Did you find and correct the condition? | -- | Go to Step 11 | Go to Step 8 | |
6 |
Did you complete the repair? | -- | Go to Step 11 | -- |
7 | Inspect for poor connections at the fuel temperature sensor and repair as necessary. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 11 | Go to Step 9 |
8 | Inspect for poor connections at the ECM and repair as necessary. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 11 | Go to Step 10 |
9 | Replace the fuel temperature sensor. Refer to Fuel Temperature Sensor Replacement . Did you complete the replacement? | -- | Go to Step 11 | -- |
10 | Replace the ECM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? | -- | Go to Step 11 | -- |
11 |
Did the DTC fail this ignition? | -- | Go to Step 2 | Go to Step 12 |
12 | Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? | -- | Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information | System OK |
