GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2000 🢒 Yukon - 2WD 🢒 Restraints 🢒 SIR 🢒 Ignition Lock Cylinder Replacement - On Vehicle

Removal Procedure

    Object Number: 779 Size: SH
  1. Set the front wheels in the straight-ahead position.
  2. Set the steering wheel in the LOCK position.

    3. Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  3. Disconnect the negative battery cable.
  4. Disable the supplemental inflatable restraint (SIR) system. Refer to Disabling the SIR System in SIR.
  5. Remove the steering column trim covers. Refer to Steering Column Trim Cover Replacement - On Vehicle .

    6. Object Number: 375970 Size: SH
  6. Turn the ignition lock cylinder to the START position.
  7. Using an awl, insert the tip into the ignition lock cylinder access hole (1).
  8. Push down and hold the ignition lock cylinder retaining pin.
  9. Release the ignition lock cylinder to the RUN position.
  10. Remove the ignition lock cylinder by pulling the ignition lock cylinder away from the steering column (2).

Installation Procedure

    Object Number: 375970 Size: SH
  1. Install the ignition lock cylinder into the steering column (2) using the following procedure:
    2. 1.1. Align the positioning locking tab slot on the lock module assembly to the positioning tab on the ignition lock cylinder.
    1.2. Push the lock cylinder in until the locking tab locks in the lock module assembly.
  2. Install the steering column trim covers. Refer to Steering Column Trim Cover Replacement - On Vehicle .
  3. Enable the SIR system. Refer to Enabling the SIR System in SIR.
  4. Connect the negative battery cable.

    5. Perform the Idle Learn Procedure for 4.8L, 5.3L and 6.0L engines only. Refer to PCM Idle Learn Procedure in Engine Controls-4.8L, 5.3L and 6.0L.

    Perform the PASSLOCK Reprogramming Auto Learn procedure. Refer to PASSLOCK Reprogramming Auto Learn in Theft Deterrent.