Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the studs and the nuts to 30 N·m (22 lb ft).
Tighten
Tighten the bolt to 29 N·m (21 lb ft).
Tighten
Tighten the bolts to 10 N·m (89 lb in).
Tighten
Tighten the bolt and the nut to 30 N·m (22 lb ft).
Tighten
Tighten the nuts to 30 N·m (22 lb ft).
Tighten
Tighten the stud nuts to 35 N·m (26 lb ft).
Tighten
Tighten the studs to 20 N·m (15 lb ft).
Tighten
Tighten the nuts to 20 N·m (15 lb ft).
Important: Use a long extension in order to remove the exhaust crossover pipe nuts.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the bolts to 10 N·m (89 lb in).
Tighten
Tighten the bolts to 20 N·m (15 lb ft).
Tighten
Tighten the bolts to 34 N·m (25 lb ft).