GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 HUMMER 🢒 2008 🢒 H2 🢒 Driver Information and Entertainment 🢒 Cellular, Entertainment, and Navigation 🢒 Digital Radio Antenna Cable Replacement

Removal Procedure

    Notice: Use care when removing and installing the headliner. If reusing the headliner lay the headliner down flat on a clean surface. Excessive bending will damage the headliner.


    Object Number: 853340 Size: SH
  1. Lower the front of the headliner. Refer to Headlining Trim Panel Replacement .
  2. Remove the instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement .
  3. Remove the right instrument panel side trim panel. Refer to Instrument Panel Side Trim Panel Replacement .
  4. Disconnect the three in one antenna cable from the antenna .

    5. Important: Note the antenna cable routing, clip and tape location during dis-assembly in order to route the cable back to factory routing.

  5. Remove tape retaining cable assembly to body harness.

    6. Object Number: 1207705 Size: SH
  6. Disconnect the three in one cable inline connector at the right side lower IP
  7. Attach mechanic wire to cable and remove through right side of IP.

Installation Procedure

    Object Number: 853340 Size: SH
  1. Attach the mechanics wire, used during removal, to the end of the antenna cable.
  2. Connect the antenna cable to the inline connector.
  3. Tape retaining cable assembly to body harness.
  4. Connect the three in one cable to the antenna.

    5. Object Number: 1207705 Size: SH
  5. Install the right instrument panel side trim panel. Refer to Instrument Panel Side Trim Panel Replacement .
  6. Install the instrument panel insulator panel. Refer to Instrument Panel Insulator Panel Replacement .
  7. Install the headliner. Refer to Headlining Trim Panel Replacement .