Rear Window Washer Pump Hose Replacement - Liftgate Liftgate

1. Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement.



2. At the right side of the liftgate, disconnect the washer hose (12).
3. Disconnect the washer hose from the electrical harness (9).



4. Disconnect the washer hose (1) from the washer nozzle (5).
5. Remove the washer hose (1) from the liftgate (2).

1. Position the washer hose (1) to the liftgate (2).
2. Secure the washer hose to the washer nozzle (5).



3. Secure the washer hose to the electrical harness (9).
4. At the right side of the liftgate, secure the washer hose (12) to the washer nozzle hose (1).



5. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement.

Rear Window Washer Pump Hose Replacement - Liftgate Body

1. Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .



2. Lower the rear edge of the headliner in order to access the washer hose to headliner hose connection. Refer to Body Rear Corner Upper Garnish Molding Replacement .
3. Disconnect the rear washer hose connection at the headliner hose.



4. Gently disconnect the electrical harness grommet (7) from the rear header.
5. Disconnect (1) the jumper harness end from (2) the main body harness electrical connector.
6. Disconnect the liftgate harness grommet (10) from the liftgate.
7. Disconnect the electrical connector (9) at the liftgate.



8. Disconnect the washer hose (12) from the liftgate retainers.
9. Disconnect the liftgate hose (12) from the washer nozzle hose at the right side of the liftgate.
10. Remove the washer hose and liftgate jumper harness from the liftgate side (10) of the vehicle.

1. Position the hose end of the jumper harness (8) into the liftgate opening.
2. Secure the hose onto the liftgate to the washer nozzle hose connection (12).



3. Secure the jumper harness grommet (10) into the liftgate opening.
4. Connect the electrical connector (9).
5. Secure the washer hose to the headliner hose union.
6. Carefully secure the jumper harness grommet (7) into the rear roof header (5).
7. Ensure the grommet is fully seated into the roof header opening (4).



8. Install the rear interior garnish molding. Refer to Body Rear Corner Upper Garnish Molding Replacement .



9. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .