Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the front propeller shaft. Refer to Front Propeller Shaft Replacement .

Tools Required

1

Nut, Drive Flange Retaining (Qty: 1)

Tip
Using the J 8614-01 , remove the retaining nut.

Tighten
319 N·m (235 lb ft)

2

Washer, Drive Flange (Qty: 1)

3

Seal, Drive Flange Washer (Qty: 1)

4

Flange, Drive Flange

5

Seal, Front Output Shaft

Tip

1. Using the appropriate tool, remove the seal.
2. Using the J 42738 , install the Front Output Shaft Seal Installer.