Important: The sunroof actuator is timed at the factory. If there is battery voltage applied to a new sunroof actuator, the pre-timed settings within the sunroof actuator are lost and cannot be reset or used to accommodate proper
installation.
There should be no battery voltage applied to a new sunroof actuator until the following conditions are satisfied:
The power sunroof actuator is installed to the sunroof control module.
Initialization Procedure
- Install the power sunroof actuator. Refer to
Sunroof Motor/Actuator Replacement.
- Ensure that all electrical harness connectors are connected.
- Turn ignition ON.
- Turn the sunroof dial to the full vent position (1).
- Press and hold the sunroof dial switch in for a minimum of five seconds to activate the sunroof initialization process. The sunroof will move to the hard stop position and will stop in the soft stop position.
- Release the switch.
Teach Mode Procedure
- Press and hold the sunroof switch in within 2 seconds of the initialization procedure.
- Hold the switch in until the sunroof moves to the full open position then moves to the closed position and stops.
- Release the switch.
- Verify the operation of the sunroof in all positions.