GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the left closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  2. Remove the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .
  3. Remove the instrument panel (IP) accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .

  4. Object Number: 692029  Size: SH
  5. Remove the screws retaining the IPC to the IP.
  6. Partially remove the IPC from the IP in order to gain access to the electrical connector.
  7. Disconnect the electrical connector from the IPC.
  8. Remove the IPC from the IP.

Installation Procedure


    Object Number: 692029  Size: SH
  1. Position the IPC to the IP.
  2. Connect the electrical connector to the IPC.
  3. Install the IPC to the IP.
  4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the screws to instrument panel cluster.
  6. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  7. Install the instrument panel (IP) accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
  8. Install the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .
  9. Install the left closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  10. If installing a new IPC. Refer to Service Programming System (SPS) in Programming.