GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Tilt the steering wheel to the full down position.
  2. Remove the left closeout/insulator panel . Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  3. Remove the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .

  4. Object Number: 740924  Size: SH
  5. Remove the screws that retain the bezel to the instrument panel.
  6. Remove the bezel from the instrument panel.

Installation Procedure


    Object Number: 740924  Size: SH
  1. Install the bezel to the instrument panel.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the screws that retain the bezel to the instrument panel.
  4. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  5. Install the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .
  6. Install the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .