GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2003 🢒 Ascender - 4WD 🢒 Body and Accessories 🢒 Body Front End 🢒 Hood Hinge Replacement

Removal Procedure
  1. Remove the hood. Refer to Hood Replacement .

    2. Object Number: 740670 Size: SH
  2. Using a grease pencil or other suitable marking device, mark the location of the hinge(s) (3) to the body.
  3. Remove the bolts (2) that retain the hinge(s).
  4. Remove the hinge(s) from the body.

Installation Procedure

    Object Number: 740670 Size: SH
  1. Position the hinge(s) (3) to the body as previously marked.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the bolts (2) that retain the hinge(s) to the body.

    3. Tighten
    Tighten the bolts to 25 N·m (18 lb ft).

  3. Install the hood. Refer to Hood Replacement .