GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 1999 🢒 Isuzu MD Steel Tilt (F Model) 🢒 Steering 🢒 Steering Wheel and Column - Tilt 🢒 Ignition Switch Replacement - On Vehicle

Removal Procedure

    Object Number: 228496 Size: MH
  1. Remove the steering wheel (3). Refer to Steering Wheel Replacement .
  2. Push the boot (8) off of the cowl halves (5, 12) onto the lower steering shaft cover (9).
  3. Remove the left and right side cowl half screws.
  4. Remove the left (12) and right (5) side cowl halves from the upper steering shaft assembly (7).
  5. Disconnect the electrical connector from the ignition switch (6).
  6. Remove the following components from the upper steering shaft assembly (7):
    7. 6.1. The ignition switch screws
    6.2. The wiring harness clamp
    6.3. The ignition switch (6)

Installation Procedure

    Object Number: 228496 Size: MH
  1. Install the ignition switch (6) to the upper steering shaft assembly (7), with the wiring harness clamp and screws.
  2. Connect the electrical connector to the ignition switch (6).
  3. Install the left (12) and the right (5) side cowl halves to the upper steering shaft assembly (7) with screws.
  4. Position the boot (8) over the lower steering shaft cover (9).
  5. Install the steering wheel (3).