Circuit Description
As a toothed ring passes by the wheel speed sensor, changes in the electromagnetic field cause the wheel speed sensor to produce a sinusoidal (AC) voltage signal. The frequency and amplitude of the sinusoidal (AC) voltage signal are proportional to the wheel speed. The amplitude of the wheel speed signal is directly related to the distance between the wheel speed sensor coil and the toothed ring. This distance is referred to as the air gap. The EBCM can detect wheel speed signal malfunctions as they happen. An error in reported wheel speed can be compensated for by the EBCM up to a point. The error compensation will allow the EBCM to continue to function normally instead of setting a DTC. If the wheel speed mismatch increases beyond that point, the EBCM will set DTC C0238.
Conditions for Setting the DTC
| • | One mismatched wheel speed is more than double or less than half the other three. |
| • | The vehicle speed is greater than 19 km/h (12 mph) |
| • | No unexpected wheel acceleration: anything that generates consistent differences between the wheel speed signals |
Action Taken When the DTC Sets
| • | The ABS indicator lamp turns on |
| • | The ABS disables |
DTC C0238 is an Ignition Latched DTC, which indicates that the above actions remain true until the ignition is turned to OFF (even if the cause of the DTC is intermittent).
Conditions for Clearing the DTC
| • | Repair the conditions responsible for setting the DTC |
| • | Use the Scan Tool Clear DTCs function |
Diagnostic Aids
Installing significantly different tires on the vehicle usually sets a DTC C0238.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Was the Diagnostic System Check performed? | -- | Go to Step 2 | |
2 | Inspect the vehicle tires for a variation in tire size Are all four tire sizes the same? | -- | Go to Step 3 | Go to Diagnostic Aids |
3 |
Does the Scan Tool indicate a mismatch in wheel speeds? | -- | Go to Step 4 | Go to Diagnostic Aids |
4 | Does the scan tool indicate a mismatch with the right front wheel speed? | -- | Go to Step 5 | |
5 | Does the scan tool indicate a mismatch with the left front wheel speed? | -- | Go to Step 6 | |
6 | Does the scan tool indicate a mismatch with the right rear wheel speed? | -- | Go to Step 7 | |
7 | Does the scan tool indicate a mismatch with the left rear wheel speed? | -- | -- |
