Conditions for Setting the DTC
The electrically erasable programmable read only memory (EEPROM) data is not written.
Action Taken When the DTC Sets
| • | The engine control module (ECM) will illuminate the malfunction indicator lamp (MIL) the first time the fault is detected. |
| • | Fuel rate data Number 8 is selected. |
Conditions for Clearing the MIL/DTC
DTC 0034 can be cleared by using the Clear Info on the scan tool or by using the Diag Clear Switch.
Step | Action | Yes | No | ||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
Schematic Reference: Engine Controls Schematics | |||||||||||
1 | Does DTC 0034 display when the ignition is ON? | Go to Step 2 | Go to Step 6 | ||||||||
2 | Assume that fuel rate data may not be written to the ECM after replacing the ECM assembly. Did you write the Fuel Rate data? | Go to Step 4 | Go to Step 3 | ||||||||
3 | Write fuel rate data to ECM use scan tool. Does DTC 0034 display after writing the fuel rate data? | Go to Step 2 | Go to Step 6 | ||||||||
4 | Does DTC 0034 display after above action done? | Go to Step 5 | Go to Step 6 | ||||||||
5 |
Important:
Replace the ECM. Refer to Engine Control Module Replacement/Restore Fuel Rate Data Did you complete the replacement? | Go to Step 2 | -- | ||||||||
6 | Operate the vehicle. Does DTC 0034 reset? | Go to Step 1 | Go to Step 7 | ||||||||
7 | Do any other DTCs set? | System OK | |||||||||
