Turn Signal Cancel Cam and Upper Bearing Inner Race - Assemble - Off Vehicle Column Shift

Tools Required

J 23653-SIR Lock Plate Compressor

1. Lubricate the following parts with synthetic grease.

•	The inner race (1)

•	The lower brass surface of the turn signal cancel cam assembly (4)

2. Install the following parts onto the steering shaft assembly.

2.1.	The inner race (1)

2.2.	The upper bearing inner race seat (2)

2.3.	The upper bearing spring (3)

2.4.	The turn signal cancel cam assembly (4)

2.5.	The shaft lock shield assembly (5)




3. Compress the shaft lock shield assembly (2) using J 23653-SIR .
4. Install the new bearing retainer (1) onto the steering shaft assembly.
5. Firmly seat the bearing retainer (1) into the groove on the steering shaft assembly.
6. Remove J 23653-SIR from the steering shaft assembly.
7. Install the SRS coil assembly. Refer to Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle .

Turn Signal Cancel Cam and Upper Bearing Inner Race - Assemble - Off Vehicle Floor Shift

Tools Required

J 23653-SIR Lock Plate Compressor

1. Lubricate the following parts with synthetic grease:

•	The inner race (1)

•	The lower brass surface of the turn signal cancel cam assembly (4)

2. Install the following parts onto the steering shaft assembly:

2.1.	The inner race (1)

2.2.	The upper bearing inner race seat (2)

2.3.	The upper bearing spring (3)

2.4.	The turn signal cancel cam assembly (4)

2.5.	The shaft lock shield assembly (5)




3. Compress the shaft lock shield assembly (2) using J 23653-SIR .
4. Install the new bearing retainer (1) onto the steering shaft assembly.
5. Firmly seat the bearing retainer (1) into the groove on the steering shaft assembly.
6. Remove J 23653-SIR from the steering shaft assembly.
7. Install the SRS coil assembly. Refer to Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle .