Tools Required

J 41239-10 Cooler Line Seal Remover

1. Raise the vehicle. Support the vehicle . Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the transmission oil cooler pipes from the transmission. Refer to Automatic Transmission Oil Cooler Pipes Replacement .



3. Remove the cooler pipe bracket stud.



4. Remove the oil cooler pipe seals.

1. Install the J 41239-1A on the transmission case using cooler pipe bracket stud hole.



2. Install a new seal in the case bore.
3. Press the new seals in. Tighten the J 41239-1A until the seal bottoms out in the case bore.



4. Install the cooler pipe bracket stud.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the transmission oil cooler pipes.

Tighten
Tighten the oil cooler lines to 8 N·m (71 lb in)

6. Lower the vehicle.
7. Inspect the transmission fluid level. Refer to Transmission Fluid Check .
8. Operate the engine for 2 or 3 minutes.
9. Inspect the transmission fluid level. Refer to Transmission Fluid Check .