GM Service Manual Online
For 1990-2009 cars only

Tail Lamp Assembly and /or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement Pontiac

Removal Procedure

  1. Pull back the rear compartment trim. Refer to Rear Compartment Trim Panel Replacement in Body Rear End.

  2. Object Number: 747917  Size: SH
  3. Remove the tail lamp thumb nuts from the tail lamp.

  4. Object Number: 747919  Size: SH
  5. Remove the tail lamp from the rear body panel.
  6. Disconnect the electrical connector from the tail lamp.

  7. Object Number: 747921  Size: SH
  8. Release the tabs to remove the circuit board from the tail lamp.
  9. Remove the required bulbs from the sockets, if replacing bulbs.

Installation Procedure


    Object Number: 747921  Size: SH
  1. Install the required bulbs to the sockets, if replacing bulbs.
  2. Install the circuit board to the tail lamp, pressing into place until the retainers are fully seated.

  3. Object Number: 747919  Size: SH
  4. Connect the electrical connector to the tail lamp.

  5. Object Number: 747917  Size: SH
  6. Position the tail lamp to the rear body panel.
  7. Install the tail lamp thumb nuts, and hand tighten.
  8. Fold the rear compartment trim to the original position. Refer to Rear Compartment Trim Panel Replacement in Body Rear End.

Tail Lamp Assembly and /or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement Oldsmobile

Removal Procedure


    Object Number: 737231  Size: SH
  1. Pull back the rear compartment trim. Refer to Rear Compartment Trim Panel Replacement in Body Rear End.
  2. Remove the tail lamp thumb nuts.
  3. Remove the tail lamp from the rear body panel.

  4. Object Number: 737240  Size: SH
  5. Disconnect the electrical connector from the tail lamp.
  6. Remove the tail lamp from the vehicle.

  7. Object Number: 737219  Size: SH
  8. Disconnect the electrical connector retainer from the tail lamp housing, if required.
  9. Remove the bulb/socket from the tail lamp by rotating counterclockwise, if required.
  10. Remove the bulbs from the sockets , if required.

Installation Procedure


    Object Number: 737219  Size: SH
  1. Install the bulbs to the sockets , if required.
  2. Install the bulb/sockets to the tail lamp by rotating clockwise, if required.
  3. Connect the electrical connector retainer to the tail lamp housing, if required.

  4. Object Number: 737240  Size: SH
  5. Connect the electrical connector to the tail lamp.

  6. Object Number: 737231  Size: SH
  7. Install the tail lamp to the rear body panel.
  8. Install the tail lamp thumb nuts, and hand tighten.
  9. Pull back the rear compartment trim. Refer to Rear Compartment Trim Panel Replacement in Body Rear End.