Removal Procedure
- Relieve the fuel pressure.
Refer to
Fuel Pressure Relief
.
- Clean any dirt from the fuel pressure regulator.
- Disconnect the fuel pressure regulator vacuum line.
- Remove the fuel pressure regulator retainer clip (1).
- Pull and twist the fuel pressure regulator (6) in order
to remove the regulator from the fuel rail. Use a shop towel to catch any
spilled fuel.
- Remove the regulator lower O-ring (2).
- Remove the filter (3).
- Remove the regulator upper O-ring (4).
- Remove the back-up ring (5).
- Cover the fuel pressure regulator housing in order to prevent
contaminants from entering the fuel system.
Installation Procedure
Notice:
• | Do not use compressed air in order to test or clean a fuel pressure
regulator as damage to the fuel pressure regulator may result. |
• | Clean the fuel pressure regulator filter screen with gasoline
if necessary. |
• | Do not immerse the fuel pressure regulator in a solvent bath in
order to prevent damage to the fuel pressure regulator. |
- Install new O-rings on the fuel pressure regulator if a
new regulator is not being installed. Lubricate the O-rings lightly with
clean engine oil.
- Install the back-up ring (5).
- Install the upper O-ring (4).
- Install the filter (3).
- Install the lower O-ring (2).
- Install the fuel pressure regulator (6) into the fuel rail.
- Install the fuel pressure regulator retainer clip (1).
- Connect the fuel pressure regulator vacuum line.
- Connect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
in Engine Electrical.
- Inspect for fuel leaks.
10.1. | Turn ON the ignition for 2 seconds. |
10.2. | Turn OFF the ignition for 10 seconds. |
10.3. | Turn ON the ignition. |
10.4. | Inspect for fuel leaks. |
- Install the fuel injector sight shield. Refer to
Fuel Injector Sight Shield Replacement
in Engine Mechanical-3.5 L.