For 1990-2009 cars only
- Install the wave washer (1).
- Align the block tooth on the steering shaft assembly (1) to the 12 o'clock position.
- If installing the existing inflatable restraint steering wheel module coil, it must be centered first. Refer to Inflatable Restraint Coil Centering - Off Vehicle .
- Align the inflatable restraint steering wheel module coil (2) with the horn tower sticking through the shaft lock shield assembly (1).
- Slide the inflatable restraint steering wheel module coil (2) onto the steering shaft assembly.
- Remove and discard the centering tab from the new inflatable restraint steering wheel module coil (2).
- Install the retaining ring (1) using snap ring pliers.
- Install the black inflatable restraint steering wheel module coil connector to the fused jumper assembly connector.
- Install the wire harness straps.
- Install the wire harness assembly into the wire restraint clip (1).
- Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
- Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.
Important: Improper alignment of the inflatable restraint steering wheel module coil may damage unit causing an inflatable restraint malfunction.
Important: A new inflatable restraint steering wheel module coil is pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil until the installation is complete.
Important: Seat the retaining ring (1) securely on the groove of the race and upper shaft assembly (2).
Caution: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.
