GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2003 🢒 Aurora 🢒 Body and Accessories 🢒 Doors 🢒 Front Side Door Window Replacement

Removal Procedure

    Object Number: 428671 Size: SH
  1. Lower the window to the full down position.
  2. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
  3. Remove the door module. Refer to Door Control Module Replacement .
  4. Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
  5. Remove the window inner belt sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement .
  6. Connect a power source to the window motor and position the window half way down.
  7. Loosen the window regulator to window clamps.
  8. Remove the window by tilting window forward then pulling the window up and out of the door.

Installation Procedure

    Object Number: 428671 Size: SH

    Important: The window regulator should be at least half way down before installing the window.

  1. Install the window down into the door.
  2. Locate the window into the two clamps.

    3. Caution: Disconnect the power window switch when working inside the driver door. When operated, the Express Up/Down Feature allows the door window to move very quickly, without stopping, which could cause personal injury.

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Connect a power source to the window motor and run the window to the full-up position.

    4. Tighten
    Tighten the window clamp fasteners to 11 N·m (98 lb in).

  4. Install the window inner belt sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement .
  5. Install the water deflector. Refer to Front Side Door Water Deflector Replacement .
  6. Install the door module. Refer to Door Control Module Replacement .
  7. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .