GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2003 🢒 Aurora 🢒 Body and Accessories 🢒 Seats 🢒 Sunshade Replacement

Removal Procedure

    Object Number: 258799 Size: SH
  1. Remove the Fasteners from the sunshade center support (1).
  2. Remove the  fasteners from the outboard side of the sunshade.
  3. Pull down on the sunshade in order to remove the sunshade from the headliner.
  4. Partially lower the headliner in order to disconnect the wire connector for the lighted vanity mirror. Refer to Headlining Trim Panel Replacement .

Installation Procedure

    Object Number: 258799 Size: SH
  1. Connect the electrical connector for the lighted vanity mirror.
  2. Install the headliner. Refer to Headlining Trim Panel Replacement .
  3. Position the sunshade to the openings in the headliner.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the fasteners on the outboard side of the sunshade.

    5. Install the fasteners for the center support (1).

    Tighten
    Tighten the fasteners to 3 N·m (27 lb in).

  5. Reposition the sunshade.