Was the Body Control Module (BCM) Diagnostic System Check performed?

--

Go to Step 2

Go to Diagnostic System Check - Body Control System in Body Control System

1. Turn the ignition switch off.
2. Disconnect the electrical connector of the inoperative door lock actuator motor.
3. Using a test light, connect between the inoperative door lock actuator motor harness connector C2 terminal A and B.
4. While observing the test light, press unlock on either door lock switch.

Does the test light flash once upon pressing lock on door lock switch?

--

Go to Step 4

Go to Step 3

1. Using a test light, connect between the inoperative door lock actuator motor harness connector C2 terminal A and ground.
2. While observing the test light, press unlock on either door lock switch.

Does the test light flash once upon pressing unlock on door lock switch?

--

Go to Step 5

Go to Step 6

Replace the door lock actuator motor. Refer to Front Side Door Lock Actuator Replacement or Rear Side Door Lock Actuator Replacement in Doors for service procedure.

Is the repair complete?

--

Go to Step 7

--

Repair poor connection or open in circuit 295.

Is the repair complete?

--

Go to Step 7

--

Repair poor connection or open in circuit 294.

Is the repair complete?

--

Go to Step 7

--

1. Turn the ignition switch off.
2. Reinstall connectors/components removed.

Is the action complete?

--

Go to Automatic Door Locks System Check

--