- Apply lithium grease to the exposed shaft engagement areas and then install the steering shaft to the centering sphere.
- Install the steering column support assembly (2) to the steering column jacket assembly (3) by using the 4 TORX® head screws (1).
- Install the steering shaft assembly to the steering column jacket assembly.
- Install the upper tilt head assembly onto the steering column support assembly.
- Install the 2 pivot pins (1).
- Install the adapter and bearing assembly (4).
- Install the lower bearing seat (3). The lower bearing seat must be in contact with the adapter and bearing assembly.
- Install the lower bearing spring (2).
- Install the lower spring retainer (1).
- Press the lower spring retainer (1) to compress the lower bearing spring (2).
- Measure the distance from the adapter and bearing assembly (3) to the lower spring retainer (1).
- The spring height must equal 15.00 mm (0.6 in).
- The upper steering shaft assembly must be rotated to the center position with the block tooth (1) in the 12 o'clock position.
- Install the bosch sensor (1).
- Install the sensor retainer (1). Align the slots of the sensor retainer to the ribs of the adapter and bearing assembly. Push the sensor retainer (1) until it contacts the analog extended range sensor assembly.
- Install the steering shaft seal (2).
- Install the tilt spring assembly. Refer to Tilt Spring - Assemble - Off Vehicle .
- Install the turn signal and multifunction switch assembly. Refer to Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle .
- Install the windshield wiper and washer switch assembly. Refer to Windshield Wiper and Washer Switch Assembly - Assemble - Off Vehicle .
- Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Important: Replace steering column support assembly after column has been staked 3 times.
Tighten
Tighten the screws to 17 N·m (13 lb ft).
Stake the pivot pins in 3 locations.
Caution: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.
