For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle |
| • | Review Strategy Based Diagnosis |
DTC Descriptor
DTC P2534: Ignition 1 Switch Circuit Low VoltageDiagnostic Fault Information
Circuit | Short to Ground | Open or High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
IGN Voltage | P2534 | P2534 | -- | -- |
Circuit/System Description
The fuel pump flow control module (FPCM) monitors the ignition voltage circuit in order to determine if the voltage is within the normal operating range.
Conditions for Running the DTC
The engine is running.
Conditions for Setting the DTC
The FPCM detects that the IGN voltage is less than 6.0 volts.
Action Taken When the DTC Sets
DTC P2534 is a Type A DTC.
Conditions for Clearing the DTC
DTC P2534 is a Type A DTC.
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Electrical Information Reference
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Circuit/System Testing
- Verify that DTC P0562 is not set.
- Ignition OFF, disconnect the harness connector of the K27 FPCM.
- Ignition ON, test for greater than 11 V between the IGN voltage circuit terminal 32 and ground.
- If all circuits test normal, replace the K27 FPCM.
| ⇒ | If DTC P0562 is set, refer to DTC P0562 |
| ⇒ | If less than the specified voltage, test the IGN voltage circuit for a short to ground or an open/high resistance. If the circuit test normal and the F67UA fuse is open, test the voltage circuit for a short to ground. If the circuit tests normal, test or replace the Run/Crank relay. |
Repair Instructions
Perform the Diagnostic Repair Verification
