Was the entire HVAC blower controls system check performed?

Go to Step 2

Go to HVAC Blower Controls System Check

1. Place the ignition switch in the RUN position.
2. Place the selector switch in the VENT position.
3. Place the blower switch in the LO position.
4. Backprobe with a test light between the blower resistor connector terminal C and ground.

Is the test light on?

Go to Step 3

Go to Step 4

Backprobe with a test light between the blower motor relay connector terminal B2 and ground.

Is the test light on?

Go to Step 5

Go to Step 6

Replace the blower resistor. Refer to Blower Motor Resistor Replacement

Is the repair complete?

Go to Step 7

--

Replace the blower motor relay. Refer to Blower Motor Relay Replacement

Is the repair complete?

Go to Step 7

--

Repair the open in CKT 101 between the blower resistor and the blower motor relay.

Is the repair complete?

Go to Step 7

--

1. Turn the ignition switch to the OFF position.
2. Reconnect all connectors/components removed.

Have all the repairs been made?

Go to HVAC Blower Controls System Check

--