Drive Belt Replacement Accessory

1. Disconnect the intake air temperature (IAT) sensor electrical connector.
2. Disconnect the mass airflow (MAF) sensor electrical connector.



3. Remove the air intake duct from the throttle body and the air cleaner box.



4. Position a hex-head socket on the belt tensioner (1) bolt.
5. Rotate the drive belt tensioner clockwise to relieve the tension on the drive belt.
6. Remove the drive belt from the tensioner and pulleys.
7. Clean and inspect the belt surfaces of all the pulleys.

1. Route the drive belt around the pulleys.
2. Position a hex-head socket on the belt tensioner (1) bolt.
3. Rotate the drive belt tensioner clockwise to relieve the tension.
4. Install the drive belt onto the drive belt tensioner.
5. Inspect the drive belt to ensure that the belt is properly aligned into the grooves of the pulleys.



6. Install the air intake duct to the throttle body and the air cleaner box.



7. Connect the MAF sensor electrical connector.
8. Connect the IAT sensor electrical connector.

Drive Belt Replacement A/C

1. Remove the accessory drive belt. Refer to Drive Belt Replacement .
2. Position a hex-head socket on the belt tensioner (1) bolt.
3. Rotate the air conditioning (A/C) drive belt tensioner clockwise to relieve the tension on the drive belt.
4. Remove the A/C drive belt from the crankshaft balancer and A/C compressor.
5. Clean and inspect the A/C belt surfaces of the balancer and compressor pulley.

1. Route the A/C belt over the crankshaft balancer.
2. Rotate the A/C belt tensioner (1) clockwise to relieve the tension.
3. Install the drive belt between the idler and the tensioner (1) and over the compressor pulley.
4. Inspect the drive belt to ensure that the belt is properly aligned on all the pulleys.
5. Install the accessory drive belt. Refer to Drive Belt Replacement .