For 1990-2009 cars only
Removal Procedure
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the special security wheel lock nut, if equipped. Use the special security wheel lock key, which is located in the front floor console.
- Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Remove the brake caliper (3). Refer to Brake Caliper Replacement in Disc Brakes.
- Remove the brake rotor (5). Refer to Brake Rotor Replacement in Disc Brakes.
- Disconnect the wheel speed sensor electrical connector. Refer to Wheel Speed Sensor Replacement in Antilock Brake System. Set the connector aside.
- Remove the bolts/screws (6) from the hub (4).
- Pull the hub from the spindle.
If the hub is difficult to remove, use a slide hammer and adapter attached to the wheel studs.
Installation Procedure
- Position the hub (4) to the spindle.
- Install the bolts and the screws (6).
- Connect the wheel speed sensor electrical connector. Refer to Wheel Speed Sensor Replacement in Antilock Brake System.
- Install the brake rotor (5). Refer to Brake Rotor Replacement in Disc Brakes.
- Install the brake caliper (3). Refer to Brake Caliper Replacement in Disc Brakes.
- Install the tire and the wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Install the special security wheel lock nut, if equipped. Use the special security wheel lock key, which is located in the front floor console.
- Lower the vehicle.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the bolts/screws to 86 N·m (63 lb ft).
Important: The wheel speed sensor electrical connector must be connected to the wheel speed sensor wire bracket (8) and to the wheel speed sensor. Otherwise the wires may be damaged.
