GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 1999 🢒 Firebird 🢒 Brakes 🢒 Antilock Brake System 🢒 Instrument Cluster Replacement

Removal Procedure

    Object Number: 208241 Size: SH
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the I/P cluster bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .

    3. Object Number: 296124 Size: MH
  3. Remove the instrument cluster bolts (1).
  4. Remove the instrument cluster (2).

    5. Gently pull the cluster straight out to disconnect the electrical connector (3).

Installation Procedure

    Object Number: 296124 Size: MH
  1. Install the instrument cluster (2).
  2. Install the instrument cluster bolts (1).

    3. Tighten
    Tighten the instrument cluster bolts (1) to 2.2 N·m (19 lb in) in sequence as shown.

  3. Install the I/P cluster bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .

    4. Object Number: 208241 Size: SH
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  5. Synchronize the instrument panel cluster (IPC).

Instrument Panel Cluster Synchronization

Tools Required

Scan Tool

When installing a new I/P cluster it must be synchronized to the SIR module. To synchronize the new cluster perform the following:

  1. Connect the Scan Tool to the data link connector (DLC).
  2. On the Main Menu select the DIAGNOSTICS key (F0:).
  3. From the menu under F0: DIAGNOSTICS select the model year ((X) 1999).
  4. From the menu under (X) 1999 press the PASSENGER CAR key.
  5. Under the PASSENGER CAR menu select the BODY key (F1:).
  6. From the menu under F1: BODY select the F key.
  7. From the menu under F select either the (1) CHEVROLET or (2) PONTIAC key.
  8. On the menu under the vehicle chosen select either the (K) 3.8L V8 L36 or (G) 5.7L V8 LS1 key.
  9. On the menu under the engine chosen select the INSTRUMENT PANEL CLUSTER (F1:) key.
  10. From the menu under F1: INSTRUMENT PANEL CLUSTER select the SPECIAL FUNCTIONS (F2:) key.
  11. From the menu under F2: SPECIAL FUNCTIONS select the SYNCHRONIZE IPC and SIR (F1:) key.
  12. When the F1: SYNCHRONIZE IPC and SIR is selected the following will appear on the screen:

    13. Do you want to synchronize IPC and SIR modules-Yes or No.

  13. Select the Yes key.
  14. The screen will display: IPC and SIR modules-Now synchronizing modules.

    15. This will remain until the procedure is complete.

  15. If the procedure is completed successfully the screen will display: Module Synchronization Complete.
  16. If communication is lost with the SIR or IPC, the screen will display: Loss of Communications with Vehicle-Check Diagnostics Link Connector-Check Ignition (On/Off).
  17. Press the Exit key to return to the previous menu.