DTC Descriptor

DTC B3675 01: Movable Roof Control Valve 2 Circuit short to battery

DTC B3675 02: Movable Roof Control Valve 2 Circuit short to ground

DTC B3675 04: Movable Roof Control Valve 2 Circuit open circuit

Circuit/System Description

The folding top uses electronically controlled valves to control the flow of hydraulic fluid. The Folding Top Control (FTC) Module controls Valve 2 (V2) by supplying voltage to the valve. The FTC Module also monitors the control circuit of V2 for proper operation.

Conditions for Running the DTC

The Folding Top Control (FTC) module is activel.

Conditions for Setting the DTC

DTC B3675 01

A short to voltage on the control circuit of V2.

DTC B3675 02

A short to ground on the control circuit of V2.

DTC B3675 04

An open on the control circuit or low reference circuit of V2.

Action Taken When the DTC Sets

The top is disabled.

Conditions for Clearing the DTC

The fault is no longer present and the top completes one cycle.

Reference Information

Schematic Reference

Folding Top Schematics

Connector End View Reference

Power Roof Systems Connector End Views

Description and Operation

Power Folding Top Description and Operation

Electrical Information Reference

Scan Tool Reference

Scan Tool Output Controls

Scan Tool Data List

Scan Tool Data Definitions

Circuit/System Testing

DTC B3675 01

Test the control circuit of V2 for a short to voltage. If circuit OK, replace FTC Module.

DTC B3675 02

Test the control circuit of V2 for a short to ground. If circuit OK, replace FTC Module.

DTC B3675 04

1. Disconnect V2.
2. Probe the control circuit of V2 with a test lamp connected to ground.
3. Command V2 on with a scan tool. The test lamp should illuminate.

⇒	If the test lamp does not illuminate, test the control circuit for an open or high resistance.

⇒	If circuit OK, replace FTC Module.

4. Probe the low reference circuit with a test lamp connected to B+. The test lamp should illuminate.

⇒	If the test lamp does not illuminate, test the low reference circuit for an open or high resistance.

⇒	If circuit OK, replace FTC Module.

5. If circuits test OK, replace V2.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Folding Top Pump with Motor Replacement

Folding Top Control Module Replacement