Inflatable Restraint Sensing and Diagnostic Module Replacement. Pontiac G6 2009

For 1990-2009 cars only

Makes 🢒 Pontiac 🢒 2009 🢒 G6 🢒 Power and Signal Distribution 🢒 Data Communications 🢒 Inflatable Restraint Sensing and Diagnostic Module Replacement

Removal Procedure

Disable the SIR system. Refer to SIR Disabling and Enabling.
Remove the console. Refer to Console Replacement.
Remove the automatic transmission shift control, if equipped. Refer to Transmission Control Replacement.
Remove the park brake lever assembly. Refer to Parking Brake Lever Replacement.
Remove the inflatable restraint sensing and diagnostic module nuts.
Remove the inflatable restraint sensing and diagnostic module wire harness connector.

Remove the inflatable restraint sensing and diagnostic module.

Installation Procedure

Point the arrow on the SDM toward the front of the vehicle.
Install the inflatable restraint sensing and diagnostic module.
Install the inflatable restraint sensing and diagnostic module wire harness connector.

Caution: Refer to Fastener Caution in the Preface section.

Install the inflatable restraint sensing and diagnostic module nuts.

Tighten
Tighten the nuts to 10 N·m (89 lb in).

Install the automatic transmission shift control, if equipped. Refer to Transmission Control Replacement.
Install the park brake lever assembly. Refer to Parking Brake Lever Replacement.
Install the console. Refer to Console Replacement.

Note: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to be set in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps thoroughly to ensure that the SDM is set properly. Refer to Control Module References.

Enable the SIR system. Refer to SIR Disabling and Enabling.
Program the inflatable restraint sensing module after replacement. Refer to Control Module References.