Special Tools

CH-48845

1. Ignition OFF.

Caution: Refer to Vehicle Lifting Caution in the Preface section.

2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.

Caution: Refer to Safety Glasses Caution in the Preface section.

3. Remove the front wheel. Refer to Tire and Wheel Removal and Installation.
4. Remove the front strut assembly. Refer to Strut Assembly Replacement.



5. Support the front strut assembly (2) in a suitable device.

Caution: Use only the CH-48845 Spring Compressor when servicing suspension components on this vehicle. Other tools may not be strong enough for the springs on this vehicle and you could be injured if you do not use Special Tool CH-48845. Failure to do so could result in serious personal injury.

Important: Observe the operating instructions of CH-48845  (2).

Important: Only use hand tools to perform the following service procedure.

6. Install the CH-48845  (3) to the coil spring (1).

Caution: Do not over compress the spring. Severe overloading may cause tool failure which could result in bodily injury.

Caution: To prevent personal injury and/or component damage, use the proper tools to support the lower control arm when removing the coil spring. The coil spring is under extreme pressure and can become a projectile should the spring separate from the lower control arm before all of the tension is relieved.

7. Compress the coil spring (1) using CH-48845  (3) until the front strut assembly (2) is free from the spring tension of the coil spring (1).
8. Remove the front strut assembly support bearing and mount. Refer to Front Suspension Strut Mount and Bearing Replacement.



9. Remove the dust boot upper retaining clamp (6).
10. Discard the clamp (6).
11. Detach and remove the coil spring seat (1) from the dust boot (5).
12. Remove the coil spring insulator (2)
13. Remove the compressed coil spring (4) from the front strut assembly (3).



14. Release the CH-48845  (2) from the coil spring (1).

Important: Observe the operating instructions of CH-48845  (2).

1. Install the CH-48845  (2) to the NEW coil spring (1).
2. Compress the NEW coil spring (1) with CH-48845  (2).



3. Install the NEW coil spring (4) to the front strut assembly (3).

Important: The coil spring insulator (2) and coil spring seat (1) have a step which locates on to the straight projecting end of the spring. The step must be correctly orientated in relation to the spring.

4. Install the coil spring insulator (2).
5. Install the coil spring seat (1)
6. Position the dust boot (5) to the coil spring seat (1).
7. Install a new dust boot upper retaining clamp (6).
8. Install the front strut assembly support bearing and mount. Refer to Front Suspension Strut Mount and Bearing Replacement.



9. Make sure that the coil spring (1) is correctly positioned to the front strut assembly (3).
10. Release the CH-48845  (2) from the coil spring (1).
11. Install the front strut assembly to the vehicle. Refer to Strut Assembly Replacement.
12. Install the front wheel to the vehicle. Refer to Tire and Wheel Removal and Installation
13. Lower the vehicle to the ground.