Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Diagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
I/P Fuse Block B+ | 2 | 2 | -- | -- |
Fuel Door Release Actuator Lock Control | 2 | 1 | 2 | -- |
Fuel Door Release Actuator Unlock Control | 2 | 1 | 2 | -- |
Relay Ground | -- | 2 | 2 | -- |
1. Fuel Door Release Actuator Inoperative 2. Fuel Door Release Actuator and Door Latches Inoperative | ||||
Circuit/System Description
The fuel door release actuator shares the circuit with the driver door latch. The body control module (BCM), upon receipt of a lock switch lock or unlock signal, will switch the appropriate door latch, as well as a fuel filler door release actuator control circuits to battery positive voltage. The opposing side of the door latch and fuel filler door release actuator is connected to ground provided by the I/P fuse block through the other the door latch control circuits, along with the fuel filler door release actuator, will lock or unlock as commanded.
Reference Information
Schematic Reference
Door Lock/Indicator Schematics
Connector End View Reference
Description and Operation
Fuel Fill Door Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Observe the operation of the power door locks while using the door lock switch. All doors and the fuel filler door should perform the LOCK and UNLOCK function.
| ⇒ | If any door does not function as commanded, refer to Power Door Locks Malfunction. |
Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the fuel door release actuator.
- Test for less than 1 ohm between the control circuit terminal 1 and ground.
- Test for less than 1 ohm between the control circuit terminal 2 and ground.
- Connect a test lamp between the control circuit terminal 1 and control circuit terminal 2.
- Ignition ON, command the doors to LOCK and UNLOCK by using the door lock switch. The test lamp should illuminate while commanding the LOCK and UNLOCK states.
- If all circuits test normal, test or replace the fuel door release actuator.
| ⇒ | If greater than the specified range, test the control circuit for a short to voltage or an open/high resistance. |
| ⇒ | If greater than the specified range, test the control circuit for a short to voltage or an open/high resistance. |
| ⇒ | If the test lamp remains OFF during either command, test either control circuit for a short to ground. |
Component Testing
- Ignition OFF, disconnect the harness connector at the fuel door release actuator
- Install a 15A fused jumper wire between the control terminal 1 and 12V. Momentarily install a jumper wire between the control terminal 2 and ground. The fuel door release actuator should perform the LOCK/UNLOCK function.
- Reverse the jumper wires. The fuel door release actuator should perform the UNLOCK/LOCK function.
| ⇒ | If the function does not perform as specified, replace the fuel door release actuator. |
| ⇒ | If the function does not perform as specified, replace the fuel door release actuator. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
