Draining Procedure
- Raise and suitably support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- Clean away all dirt and debris from the transmission fluid drain plug and backup lamp switch area.
- Disconnect the backup lamp switch electrical connector from the switch.
- Remove the backup lamp switch from the transmission.
- Remove the drain plug.
- Allow the system to drain.
Notice: Refer to Fastener Notice in the Preface section.
- Install the transmission fluid drain plug.
Tighten
Tighten the transmission fluid drain plug to 28 N·m (21 lb ft).
Filling Procedure
- Fill the transmission with DEXRON®-III transmission fluid, until even with the bottom of the backup lamp switch hole.
- Install the transmission backup lamp switch.
Tighten
Tighten the transmission backup lamp switch to 27 N·m (20 lb ft).
- Lower the vehicle.