DEFINITION: The IP compartment lamp stay on when the IP compartment is closed. However, the inadvertent load (battery rundown) protection may turn off IP compartment lamp after 10 minutes.

Was the Interior Lights System Check performed?

--

Go to Step 2

Go to Interior Lamps System Check

Was the BCM Diagnostic System Check performed?

--

Go to Step 3

Go to Diagnostic System Check - Body Control System in Body Control System

Inspect the IP compartment lamp switch for proper contact and interface with the IP compartment.

Were any problems found with the contact and operation of the IP compartment lamp switch?

--

Go to Step 4

Go to Step 5

Repair the interface between the IP compartment lamp switch and the IP compartment.

Is the repair complete?

--

Go to Step 8

--

Disconnect the IP compartment switch electrical connector.

Does the IP compartment lamp turn off?

--

Go to Step 6

Go to Step 7

Replace the IP compartment lamp switch.

Is the repair complete?

--

Go to Step 8

--

Repair the short to voltage in circuit 148.

Is the repair complete?

--

Go to Step 8

--

1. Turn the ignition switch to the OFF position.
2. Reinstall the connectors and components that were removed.
3. Turn the ignition switch to the RUN position for 6 seconds.
4. Turn the ignition switch to the OFF position.
5. Remove the MALL PGM fuse.
6. Turn the ignition switch to the ACC position. (The BCM sounds the chime a number of times equivalent to the BCM type installed on the vehicle.)
7. Within one second, turn the ignition switch from the ACC position, to the OFF position, then back to the ACC position. (The BCM sounds any DTCs stored.)

Are there any BCM DTCs present?

--

Go to Diagnostic System Check - Body Control System in Body Control System

Go to Interior Lamps System Check