Sunroof Control Module Programming and Setup One Connector System

This programming and setup is used for the one connector Sunroof System that uses the combination sunroof motor/actuator.

The sunroof motor/actuator uses sensor inputs to continuously monitor the location of the glass panel and to establish soft stop locations several millimeters ahead of the hard stops (physical limits) of the glass panel. The sunroof motor/actuator includes the sunroof motor, actuator, sensors and the control module. These components are not serviced individually.

If the sunroof motor/actuator is replaced, the initialization procedure must be performed in the following order:

1. Place the ignition switch to the ON position.
2. Press and hold the sunroof switch to the CLOSE position until the glass panel stalls at the hard stop position and moves back to the soft stop position.
3. Release the sunroof switch.
4. Verify sunroof operation. Refer to Sunroof Description and Operation .

The programming procedure is not complete if one of the following actions occurs before the procedure is complete:

This component is not re-programmable.

If battery positive voltage or ground is removed and re-installed from the sunroof motor/actuator, the following procedure must be performed in the following order:

1. Place the ignition switch to the ON position.
2. Press and hold the sunroof switch to the CLOSE position until the glass panel stops at the front soft stop position.
3. Release the sunroof switch.
4. Press and hold the sunroof switch again to the CLOSE position for 13 seconds. The sunroof will stall at the hard stop position, then move back to the soft stop position.
5. Release the sunroof switch.
6. Verify sunroof operation. Refer to Sunroof Description and Operation .

The re-initialization procedure is not complete if one of the following actions occur before the procedure is complete:

Sunroof Control Module Programming and Setup 2 Connector System

This programming and setup is used for the 2 connector Sunroof System that uses the sunroof control module.

If the sunroof control module is replaced, the sunroof track timing synchronization must be performed. Refer to Sunroof Track Timing/Synchronization .

This component is not re-programmable.

If the sunroof control module requires re-initialization, refer to Sunroof Track Timing/Synchronization .