Tools Required

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.

Caution: Refer to SIR Caution in the Preface section.

2. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling in SIR.
3. Remove the steering wheel inflatable restraint module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.



4. Remove the steering wheel nut (1).



5. Remove the steering wheel using J 1859-A and J 42578 .



6. Remove the steering wheel (2) from the steering column (3).

1. Install the steering wheel (2) to the column (3).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the steering wheel nut (1).

Tighten
Tighten the nut to 41 N·m (30 lb ft).

3. Install the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
4. Enable the SIR system. Refer to SIR Disabling and Enabling in SIR.
5. Connect the negative battery cable.