For 1990-2009 cars only
Removal Procedure
- Remove the fuel pump module assembly. Refer to Fuel Pump Module Replacement .
- Remove the fuel pump and fuel level sensor electrical retaining clip at the top of the fuel sender assembly.
- Disconnect the fuel pump and fuel level sensor electrical connector.
- Depress the 3 tabs (1) securing upper fuel reservoir and slide upward until free of lower reservoir (2).
- Depress the tab on the fuel level sensor (1) while sliding up and out of the housing.
- Remove the retaining clip from the electrical connector.
- Remove the fuel level sensor wires from the connector, taking care to note the location of the wires.
Installation Procedure
- Install the fuel level sensor (1) by sliding the sensor down in the housing.
- Slide the upper reservoir into the lower reservoir (2).
- Connect the 2 wires into the connector and lock the connector with the retaining clip.
- Connect the fuel pump and fuel level sensor electrical connector and lock the connector with the retaining clip.
- Install the fuel pump module assembly. Refer to Fuel Pump Module Replacement .
Important:
• Make sure the wires are routed under the fuel level sensor. • Make sure the tab locks in place.
